FAUCET REPAIR, ENNIS, TX
Faucet Repair & Installation in Ennis, TX
Most drips are a worn cartridge or seat, not a reason to replace the whole fixture.
Why faucets wear the way they do here
The City of Ennis supplies municipal water drawn from Bardwell Lake, and like most surface-water sources in Texas, it carries dissolved minerals that leave deposits over time inside valve bodies, cartridges, and aerators. That mineral buildup is the single biggest reason a faucet starts dripping, sticking, or requiring more force to shut off fully even when nothing about the fixture has been damaged. It's a slow, cumulative wear pattern rather than a sudden failure, which is why a faucet that worked fine last year can start acting up with no obvious trigger.
Homes in Ennis's older neighborhoods often still have original or early-replacement fixtures with compression-style valves, which use a rubber washer that compresses against a seat, versus the ceramic disc or cartridge valves standard in newer construction. Compression valves wear differently and usually need the washer and sometimes the seat itself replaced, while cartridge faucets typically just need the cartridge swapped.
Not sure if this can wait? Call and we'll tell you honestly.
CALL NOW(972) 430-3932Repair or replace: what actually decides it
A dripping faucet is almost always repairable. If the fixture itself is in good shape and the problem is a worn cartridge, valve seat, or O-ring, replacing that single part restores normal function for a fraction of the cost of a new faucet. We carry cartridges for most major brands and can usually complete this kind of repair in one visit.
Replacement makes more sense when the faucet body itself has failed, when it's decades old and parts are no longer manufactured, or when someone's simply ready for an upgrade during a kitchen or bathroom remodel. Installation on a newer faucet is usually straightforward, but older homes sometimes have supply line configurations or shutoff valves that need updating at the same time to do the job correctly.
| Symptom | Likely cause | Typical fix |
|---|---|---|
| Slow, steady drip from the spout | Worn cartridge or washer | Cartridge or washer replacement |
| Handle hard to turn or won't fully shut off | Mineral buildup in the valve | Valve cleaning or cartridge swap |
| Low flow from a specific faucet only | Clogged aerator | Aerator cleaning or replacement |
| Leaking at the base of the handle | Worn O-ring | O-ring replacement |
What to do first
- Note whether the drip is constant or only when the handle is in a certain position
- Check the aerator for buildup before assuming it's an internal valve issue
- Know your faucet's brand if possible; it speeds up sourcing the right cartridge
- Turn off the shutoff valves under the sink before attempting any DIY fix
- If a faucet is original to a much older home, ask about the supply line condition too
Frequently asked about faucet repair & installation
Why does my faucet drip even after I've replaced the washer myself?
If the drip continues after a washer swap, the valve seat itself may be scored or worn from mineral buildup, which means the washer can't seal against it properly no matter how new it is. That usually needs the seat resurfaced or the whole cartridge replaced.
Is it worth repairing an old faucet or should I just replace it?
If the fixture is otherwise in good condition and parts are available, repair is almost always the more economical route. Replacement makes sense once parts are discontinued or the fixture is failing in more than one place at once.
Does hard water actually shorten a faucet's lifespan?
Yes, mineral deposits from surface water sources like Bardwell Lake accelerate wear on internal valve components over years of use, which is part of why faucets in this area sometimes need cartridge replacement sooner than the fixture's rated lifespan suggests.
Can you match a faucet finish to my existing fixtures?
We carry and can source faucets across the common finishes, and for a repair rather than a full replacement, we're only working with the parts inside, so the visible finish isn't affected at all.
How long does a typical faucet repair take?
A cartridge or washer replacement is usually a same-visit repair, generally under an hour for a standard fixture once we've identified the part needed.
Related to faucet repair & installation
If mineral buildup is affecting more than one fixture in the house, that's often a sign it's worth talking about Water Softener Installation & Repair rather than repairing fixtures one at a time.
Ready to handle your faucet repair & installation?
Call and describe what's going on. You'll reach a plumber, not a form.